CUCM Enabling the VoIP service
Files Needed Once the basic configuration, you can configure the Cisco Unified Communications Manager Express.
should bear in mind the interactions that occur between CUCM and IP phone, since that first assigned by the router to the IP phone is an IP address, then checks the attached device, and if telephone previously loaded firmware is housed in the flash, and finally, assigns VLAN and IP address corresponding final.
The first thing you should do is copy the files necessary to run IP phones. In this case, the images stay in flash SCCP Cisco IP Phone 7940G. Therefore, a Cisco CCO account, you must download the latest version of firmware of these IP phones.
The web address is http://www.cisco.com/cgi-bin/tablebuild.pl/ip-key discharge, which display a list of files as shown and described below in Figure:
files shown in the image x files necessary to run IP phones, web interface, IVR, among other features. The difference in version is presented and is significant in the "release", which tells us which version of CUCM must be available in the IOS to work with the respective package files.
This is important to know and apply this set of files properly. A guide for this is the compatibility matrix for CUCM version of IOS. She is presented in the following web address:
http://www.cisco.com/en/US/docs/voice_ip_comm/cucme/requirements/guide/33matrix.htm.
kyrios
0 comments:
Post a Comment